MILPRF55110G
3.7
3.7 Qualifying activity on-site audit. Manufacturers listed on QPL55110 will be required to undergo periodic on-
site audits of their facilities by the qualifying activity. The manufacturer shall demonstrate to the qualifying activity that
controls have been implemented to assure compliance to the requirements of this specification. The qualifying
activity reserves the right to perform on-site audits of any other facilities, such as contracted services, that the
manufacturer uses for producing printed boards to this specification.
3.8
3.8 Workmanship. Printed wiring boards shall be processed in such a manner as to be uniform in quality and shall
be free from defects that exceed those allowed in this specification that could affect life or serviceability.
4
4. VERIFICATION
4.1
4.1 Classification of inspections. The inspection requirements specified herein are classified as follows:
a.
b.
c.
4.2
4.2 Printed wiring board performance verification.
4.2.1
4.2.1 QPL. Printed wiring board performance verification inspection shall consist of inspections on the production
printed wiring boards and the quality conformance test circuitry or test coupons referenced in appendix A.
4.2.2
4.2.2 QPL/QML. The minimum requirements for printed wiring board performance verification to the QPL/QML
product assurance level shall satisfy the guidelines of appendix B.
4.3
4.3 Qualification inspection. Qualification is possible by two different methods based on the product assurance
4.3.1
4.3.1 QPL. Qualification inspection for the QPL product assurance level shall be performed at a laboratory
acceptable to the Government (hereafter referred to as a "certified suitable laboratory", see C.5) on qualification test
specimens produced with material, equipment, and procedures that will be used in subsequent production (see 6.3).
The requirements concerning the qualification test specimens, number of specimens to be tested, and the test
routines they shall be subjected to, and the extent of qualification shall be as specified in appendix A.
4.3.2
4.3.2 QPL/QML. The minimum requirements for qualification to the QPL/QML product assurance level shall be as
specified in appendix B.
5
5. PACKAGING
5.1
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified in the contract or order
(see 6.2). When packaging of materiel is to be performed by DoD or in house contractor personnel, these personnel
need to contact the responsible packaging activity to ascertain requisite packaging requirements. Packaging
requirements are maintained by the Inventory Control Point's packaging activities within the Military Service or
Defense Agency, or within the Military Service's system commands. Packaging data retrieval is available from the
managing Military Department's or Defense Agency's automated packaging files, CD-ROM products, or by contacting
the responsible packaging activity.
4
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business